Pages

Recent Posts

Recent Comments

    January 2018
    M T W T F S S
    1234567
    891011121314
    15161718192021
    22232425262728
    293031  

    Day: January 2, 2018


    • Installation of wall panels from boards

      Installation of wall panels from boards

      Nailing the boards. The cladding boards are nailed with wheeler nails (with cylindrical, narrow head), length 30-40 mm, to an aligned grate. Drive the nail diagonally, into the inner crest of the gully.

      Ukośny kierunek przybijania jest podyktowany

    • Joining cladding boards with tongue and groove

      Joining cladding boards with a tongue and groove is also a common method.

      Drawing. Carpet board joints with a tongue and groove: a) Face joint with a convex rectangular groove, b) Face joint with a convex trapezoidal groove, …

    • Foreign feathers

      Foreign feathers

      The foreign feathers are made of the same material as the boards. Feathers from others, contrasting types of wood are rarely eye-catching. The wood itself has such an interesting pattern, that its additional emphasis rarely increases the aesthetics.

      Proces wyrabiania obcych piór

    • The shape of the cross-section of upholstery boards – panel wall

      The shape of the cross-section of upholstery boards – panel wall

      Connector cross-sections can have a different profile. They are primarily used to securely connect and fasten boards and for aesthetic purposes. However, we advise against complex profiling, especially amateurs, because they significantly increase the labor intensity, nie

    • Solid wood wall panels

      Planks and slats are the most common panel material. They can be used to line internal and external surfaces, ceilings, walls, attic, staircases, niches, inter-window planes, tops etc..

      We pay attention again, that the wood must be properly dried. Wszystko to co omówiono w poprzednich

    • Placing grate strips under wall panels

      Placing grate strips under wall panels

      We perform mounting and screwing of the grate slats simultaneously. In order not to waste time on making various supports during the installation of the grate, we prepare them in advance in sufficient quantity and of different thickness. For washers approx 1 mm …

    • Strips for wall panels

      Strips for wall panels

      Selection of the profile and the spacing of the assembly grate

      As a rule, the width of the grate slats is 50 mm, thickness 18-25 mm (the most common 20 mm).

      The mounting grate always runs perpendicular to the direction of the covering strips.

      The center distance of the grate slats will depend on …

    • Preparation of the substrate for the elements of wall panels

      Cladding with wood requires paying due attention not only to the elements of the floor covering, but also for the preparation of the substrate. As a rule, none of the walls, nor ceilings, or floors, are not so equal, to be able to attach the grate directly to it. The unevenness of the lined surfaces may …